MIL-W-8939A (MI)
(Unless otherwise indicated, copies of the federal and military
specifications, standards, and handbooks are available from the
Standardization Documents Order Desk, Bldg. 4D, 700 Robbins Ave.,
Philadelphia, PA 19111-5094.)
2.2
Non-Government publications .
The following documents form a part
of this specification to the extent specified herein.
Unless otherwise
specified, the issues of the documents which are DoD adopted are those listed
in the issue of the DODISS cited in the solicitation.
Unless otherwise
specified, the issues of documents not listed in the DODISS are the issues of
the documents cited in the solicitation (see 6.2).
RESISTANCE WELDER MANUFACTURERS ASSOCIATION (RWMA)
BULL
34
-
Standard Resistance Welding Electrode Numbers
and Alloys, Manufacturer's Cross Reference of
(Application for copies should be addressed to the Resistance Welders
Manufacturers Association, 1900 Arch Street, Philadelphia, PA 19103.)
AMERICAN SOCIETY FOR TESTING AND MATERIALS
M e t h o d of Preparation of Metallographic
Specimens
(Application for copies should be addressed to the American Society for
Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.)
(Non-Government standards and other publications are normally available
These
from the organizations that prepare or distribute the documents.
documents also may be available in or through libraries or other informational
services.)
2.3
In the event of
a conflict between the text
Order of precedenced.
of this document and the references cited herein,
the text of this document
shall take precedence.
Nothing in this document,
however, supersedes
applicable laws and regulations unless a specific
exemption has been obtained.
REQUIREMENTS
3.
The requirement specified herein are considered
3.1 Applicability.
applicable in most of the conditions encountered in resistance welding of
electronic circuits. When special conditions are encountered which render the
requirements of this specification inapplicable, the contractor shall Submit,
at the direction of the contracting officer, alternate procedures and
requirements for approval by the procuring activity.
This specification covers resistance welding of the
3.2 Materials.
following materials for electronic use:
Group A - Pure nickel ribbon and wire.
Group B - Nickel-base and iron-base alloys.
Group C - Copper and copper alloys.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business