MIL-DTL-22200-1 Electrodes, Welding, Mineral Covered, Iron-Powder, Low-Hydrogen Medium And High Tensile Steel, As-Welded Or Stress-Relieved Weld ApplicationThis specification covers iron-powder, low-hydrogen types of mineral covered electrodes, for the fabrication and repair welding of low and medium carbon and high tensile steels for as-welded and stress-relieved application.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-DTL-22200/1H(SH)

m. If alternate restraint methods than fixturing are acceptable to minimize angular distortion of test welds (see

table XIII, footnote 2).

If welding is to be performed using other than DCEP (see figure 2, footnote 1).

If certification of conformance is not required (see 4.5.4).

6.3 Qualification. With respect to products requiring qualification, awards will be made only for products

which are, at the time of award of contract, qualified for inclusion in Qualified Products List QPL No. QPL-22200-

65 whether or not such products have actually been so listed by that date. The attention of the contractors is called

to these requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the

Federal Government tested for qualification in order that they may be eligible to be awarded contracts or orders for

the products covered by this specification. Information pertaining to qualification of products may be obtained from

Commander, Naval Sea Systems Command, ATTN: SEA 05M2, 1333 Isaac Hull Avenue, SE, Stop 5160,

Washington Navy Yard DC 20376-5160 or emailed to CommandStandards@navy.mil.

6.4 Subject term (key word) listing.

Heat input

Hydrogen, diffusible

MIL-7018-M

MIL-8018-C3

MIL-8018-C3SR

MIL-9018-M

MIL-11018-M

Moisture, coating

Wire, core

6.5 Changes from previous issue. Marginal notations are not used in this revision to identify changes with

respect to the previous issue due to the extent of the changes.